Description

A retanuglar wood printing block of a "$" (dollar sign). Block is in two pieces. Block 1: Front: rectangular wooden block created by the interlocking of several smaller rectangular pieces of wood using the tongue and groove joint.The wood block has a red tinge to ir. The carved design on the front of the block is the top 3/4 of a backwards dollar sign. The bottom portion of the block has separated. The design is the full width and length of the recessed base wood block. Side: there is a lebel on the right side with the previous number written on it. There is a 0.5cm wide groove in the bottom side. It goes across the full width. Back: the back is just a flat piece of wood. Second Block: Rectangular wooden block created by the interlocking of several smaller pieces of wood using the tongue and groove joint. Front: this block is the bottom portion of the dollar sign and the largest part of the block. The bottom is the width and length of the base of the block. It is a curve with a line through the middle. Side: there is a lebel on the right side with the previous temporary number written on it. Back: flat piece of wood

Materials

Wood (basswood or pine)

Measurements

46.8 cm L x 16.2 cm W x 2.2 cm H

Marks/Labels

Category

Printing T&E